Truck Specs

• 2020 Ford F-450 60” CA and Ford F550 84” CA

Lift Specs

• DTAS-38TS Non Insulated telescopic/articulating aerial lift
• 38’ of platform height
• 43’ of working height
• 27’6” of side reach
• 10’ Stowed travel height
• 370° Non-continuous rotation with a rotation stop limit switch
• Bucket:
• Platform capacity of 350lbs
• 24” x 30” x 42” walk-thru with a door
• End mounted
• Bucket controls:
• Toggle switch controls
• E-Power
• Engine Start/Stop
• Lower controls with override and E-Power
• Stabilization:
• Page | 3
• Stable ride torsion bars
• Timbrens as needed
• Non-relube bearings used throughout
• Intergral hydraulic oil reservoir with dual sigh gauges and 17 gallon capacity
• Emergency power 12VDC hydraulic system
• Master/slave hydraulic leveling with upper and lower control tilt for cleanout or rescue Upper boom storage cradle with ratchet type tie down strap and tubular rubber platform support
• Safety harness and lanyard
• Standard white urethane paint
• Two operators manuals and two services manuals
• ANSI 92.2 Data Plate

Body Specs

• Model: Reading Classic II Service Body 108” (60” CA)
• A60 Galvanneal steel construction
• Exterior and interior to be painted to match cab
• 20” Compartment Depth
• All compartment doors keyed alike with two stage rotary latches
• Underside of service body will be LINE-X
• Drop in tailboard
• Two non-skid steps will be built into the right side of the truck rear
• An ICC diamond plate tailpiece shall extend 30” and can be equipped with ½” draw plate with “D” rings and a 2” receiver tube
• A rubber basket rest shall be installed on the rear deck for supporting the basket while traveling over the road while the basket is in the upright position.
• All tail lights will be recessed and reflectors as required by state and federal laws shall be installed on the tail piece.
• Rock guards shall be installed in the front lower corners of the service body